How To Operate Function Menu; How To Conduct Automatic Measurement - Owon FDS Series User Manual

Data Error Set the trigger condition to bit data error.
Auto
Normal
Mode
Single
HoldOff
100ns
Sensitivity

How to operate function menu

In the function menu control area, there are 8 function menu keys,
including Measure, Acquire, Settings, Cursor, Math, Copy, Save and
Display, and 3 Execute Now keys, including AutoSet, Run/Stop and Single.

How to conduct automatic measurement

Press Measure key or click Main Menu window and select Measure
menu to conduct automatic measurement; there are 43 kinds of
measurement including horizontal measurement, vertical measurement,
Blend measurement and Inter-CH measurement, and a maximum of 8
measuring types can be displayed at the lower left of the screen.
Horizontal Measurement includes: Period, Frequency, + Width, -
Width, Rise Time, Fall Time, Positive Duty Ratio, Negative Duty Ratio and
Screen Pulse Width Ratio;
Vertical Measurement includes: Average Value, Peak-to-Peak Value,
Root-mean-square Value, Maximum Value, Minimum Value, Top Value,
Bottom Value, Amplitude, Pre-shoot, Over-shoot and Cycle
Root-mean-square Value,Standard deviation；
Mixed Measurement includes: Number of Positive Pulse, Number of
5.Use the Oscilloscope
Use General knob and arrow keys on
Data
the panel to set the ID valued required.
Set to collect waveform even when no trigger
condition is detected.
Set to collect waveform only when trigger
conditions are satisfied.
Set to acquire a waveform when one trigger is
detected and then stop acquisition.
100ns – 10s; click Numeric Input Box to input the
interval to be set for restarting the trigger circuit
and click the unit to confirm; or click Gear Input
Box (- or +) or turn the General knob to set the
interval for restarting the trigger circuit, and click
< > or press or
select the digit to be set.
Set the trigger hold-off time as 100ns.
Set the sensitivity of the trigger window.
58
to move the cursor and