Table of Contents
Advertisement
Chapter 6: Configuring the Switch for Stand-alone Operations
Saving Your Changes and Rebooting the Switch
106
After disabling the VCStack feature or configuring the 1.0.17 and 1.0.21
transceiver slots for breakout cables, you have to save your configuration
changes and reboot the switch. Changes to the status of the VCStack
feature and QSFP+ transceiver slots do not take affect until after you
reboot the unit.
To save your configuration changes and reboot the switch, perform the
following procedure:
1. From the Global Configuration mode, enter the EXIT command to
return to the Privileged Exec mode, as shown in Figure 61.
awplus(config)# exit
awplus#
Figure 61. Returning to the Privileged Exec Mode
2. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 62.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 62. Saving the Changes with the WRITE Command
If this is the initial management session, the switch automatically
creates the Default.cfg configuration file and stores your change in the
file.
3. Enter the REBOOT command to reboot the switch.
4. At the confirmation prompt, type "Y" for yes.
5. Wait two minutes for the switch to initialize its management software
and afterwards examine the Switch ID LED again. The switch is ready
for normal network operations as a stand-alone unit if its ID number is
"0." If the number is not "0," repeat the procedures in this chapter,
being sure to save your configuration changes with the WRITE
command.
6. Go to Chapter 7, "Cabling the Networking Ports" on page 109.
Advertisement
Table of Contents
