Table of Contents
Advertisement
Chapter 5: Configuring the Switch for Stand-alone Operations
Warning; This will disable the stacking hardware on member-1.
Are you sure you want to continue? (y/n):
80
The ID parameter is the ID number of the switch, displayed on the ID
LED. Replace the parameter with whatever number is on the ID LED.
For example, if the ID number of the switch is 1, the default value,
enter the command as follows:
awplus(config)# no stack 1 enable
This confirmation prompt in Figure 37 is displayed.
Figure 37. Confirmation Prompt for the NO STACK ENABLE Command
7. Type Y to disable VCStack on the switch or N to cancel the procedure.
8. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 38.
awplus(config)# exit
awplus#
Figure 38. Returning to the Privileged Exec Mode
9. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 39 on page
80.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 39. Saving the Changes with the WRITE Command
10. Enter the REBOOT command to reboot the switch.
11. At the confirmation prompt, type "Y" for yes.
12. Wait for the switch to initialize its management software and
afterwards examine the Switch ID LED. The switch is ready for normal
network operations as a stand-alone unit when its ID number is "0."
Refer to the Software Reference: AlliedWare Plus Operating System
for IX5-28GPX Switches for instructions on how to configure the
operating parameters. If the number is not "0," repeat this procedure.
Advertisement
Table of Contents
