Figure 38: Returning To The Privileged Exec Mode; Figure 39: Saving The Changes With The Write Command - Allied Telesis AT-XS916MXT Installation Manual

7. Enter the EXIT command to return to the Privileged Exec mode, as
shown in Figure 38.
awplus(config)# exit
awplus#
Figure 38. Returning to the Privileged Exec Mode
8. Enter the WRITE command to save your change in the configuration
file. The switch displays the confirmation prompt in Figure 39.
awplus# write
Building configuration ...
[OK]
awplus#
Figure 39. Saving the Changes with the WRITE Command
9. Enter the REBOOT command to reboot the switch.
10. At the confirmation prompt, type "Y" for yes.
11. Wait for the switch to initialize its management software and
afterwards examine the Switch ID LED.
If the ID number is "0," the switch is ready for normal network
operations as a stand-alone unit. Refer to the Software Reference for
XS916MX Series Switches, AlliedWare Plus Operating System, for
instructions on how to configure the operating parameters. If the
number is not "0," repeat this procedure.
XS916MX Series Installation Guide for Stand-alone Switches
65