Seats; Half Windshield (Ltd Models) - BRP Can-Am Commander 2014 Series Predelivery Bulletin

Seats

tbl2011-0011-035_a
1. Driver's seat
2. Passenger's seat
3. Latch to release the seat
1. Insert the seat in the cockpit.
2. Install the seat support into retaining brackets.
3. Push down the backrest to latch the seat.
Seat Latch Adjustment
If the seat is hard to lock, the seat latch pin must
be readjusted.
Loosen retaining screws and reposition the seat
latch pin.
tbl2011-001-062

Half Windshield (LTD Models)

REQUIRED PARTS
Half windshield
Hal windshield installation kit
(from predelivery box #1)
1. Install windshield on a clean, non abrasive sur-
face with the interior facing up.
2. Install a neoprene seal on LH and RH side along
the straight edges of the windshield.
PREDELIVERY
tsi2011-009-004_a
1. Neoprene seal
3. Turn windshield upside down to have outside
facing up.
4. Push the strap holders to snap into the slots in
windshield.
tsi2011-009-012
QTY
2
1
tbl2012-003-025
5. Install windshield supports at the bottom of
windshield as per the following illustrations.
Ensure windshield support is properly
NOTE:
seated against windshield.
2014-2
PARTS TO BE INSTALLED
29 / 54