Cabletron Systems SmartCell 6A000 Reference Manual page 72

Output Parameter
[LES Address]
[Distribute VPI/VCI]
[Distribute Method]
[LAN Type]
[BUSATMAddress]
Descriptions
Operator Parameters/Permissions
add elan [ELANNumber] <elannumber>
[ELANName] <elanname>
[ConnectMethod] <connectmethod>
[ELANType] <elantype>
[Multipoint] <distributevcctype>
[MTU] <maximumframesize>
[Distribute]
<controldistributevccoption>
Administrator
delete elan [ELANNumber] <elannumber>
Administrator
show elan [ELANNumber] <elannumber>
All
2-48 SmartCell 6A000/ZX-250 Reference Manual
Description
ATM address of the LANE server.
VPI/VCI values of the control direct VCC or multicast send VCC.
Indicates whether the control distribute VCC is established for ALL clients or only
PROXY clients.
Type of ELAN.
ATM address of the BUS (specify when the LES and BUS are not co-located).
Description
Quickly configures the switch. This command adds the
ELAN entry in all three databases (BUSELAN,
LESELAN, and LECSELAN) and activates the ELAN.
Quickly configures the switch. This removes a specific
ELAN. This command first checks that all servers
(LECS, LES, and BUS) exist before deleting any of
them.
Displays an ELAN created by either the quick
or the multiple set of commands to add an ELAN. There
might not be LECS information (as seen in the first
example) if the ELAN was created by
and
add leselan add lecselan
The LECS information is displayed if you use
or if not, after you enter
add lecselan
following B example below).
Console Commands
add elan
, and
add buselan
had not been completed.
add elan
(as seen in the