Cabletron Systems SmartCell 6A000 Reference Manual page 249

Boot Load Commands
go
Use the command to exit the boot load prompt and run switch software (with or without POST).
go
Parameter Explanation
Bypass POST and go directly to switch software.
s
Run POST, and then run switch software.
p
none Same as
Example
=>go s
Bypassing POST
Verifying Checksum of Switch Software...
Attaching network interface ei0... done.
Attaching network interface lo0... done.
0xe054f600 (tRootTask): flashFsLib: Initialized
Initializing Flash File-System
Initializing System
Initializing Hardware
Initializing Alarms, Logging and Tracing
Initializing ILMI
Initializing PM
Initializing Link Daemon
Initializing LANE Servers
NOTICE - 'ZLESSRV' ***** LES started *****
NOTICE - 'tZLinkStatus' Port A1
NOTICE - 'tZLinkStatus' Port A2
Initializing LANE & IP/ATM Client
NOTICE - 'tZLinkStatus' Port C1
Initializing Watchdog Timer
After ZKickWatchDog
Console task ID : 0xe04c4cb0
SmartSwitch Command Console
SmartSwitch Version 02.01(31) (c) Cabletron Systems Inc.
password:
; bypass POST and go directly to switch software.
s
(1) UP
(2) UP
(9) DOWN
SmartCell 6A000/ZX-250 Reference Manual 3-7