Boot Load Commands - Cabletron Systems SmartCell 6A000 Reference Manual

Boot Load Commands

3 BOOT LOAD COMMANDS
This chapter describes the low-level boot load commands. Boot load commands are used for setting switch start-up
behavior and for performing software downloads. Use the boot load commands to:
•
Set which copy of the boot load software is the default copy
•
Clear all configurations stored within the flash file system
•
Check boot load software version numbers
•
Load switch software upgrades
•
Set whether power on system tests (POST) are run by default
2p›F
For detailed information on using the boot load Commands, see your product's
SmartCell User Guide.
%"¤›apm
The commands described in this section are intended to be used only for loading
upgrade software or to reinstall software that has become corrupt.
SmartCell 6A000/ZX-250 Reference Manual 3-1