Ponf - Cabletron Systems SmartCell 6A000 Reference Manual

Boot Load Commands

ponf

Use to set whether POST diagnostics are run by default when the switch is started.
ponf
Parameter Explanation
POST is off. Switch goes directly to start-up.
s
POST is on. Switch runs POST before going to switch
p
operating software.
none Same as
Example
=>ponf p
Modifying Control/Stat field to execute POST, please wait...
New postOnOff value programmed successfully into Control/Stat field.
=>
2p›F
ponf
; POST is off.
s
does not affect the behavior of the command.
go
SmartCell 6A000/ZX-250 Reference Manual 3-9