Cabletron Systems SmartCell 6A000 Reference Manual page 227

Console Commands
Output Parameter
[SAR Control SRAM]
[Power Mode]
[Number of Switch
Boards]
[Switch Board 1 Rev.]
[Switch Board 1 ID]
[Switch Board 2 Rev.]
[Switch Board 2 ID]
[Cell Memory Size]
[Number of Quad
Boards]
[Number of Ports]
[Quad Board Type]
[IP Address]
[MAC Address (Base)]
[Switch Software Type]
[Software Version]
Description
SAR control memory size.
Type of power modules used by the
switch.
Number of switch boards on the system. 1, 2
Revision number of Board 1.
ID number of Board 1.
Revision number of Board 2.
ID number of Board 2.
Total cell buffer size.
Number of quad boards on the system.
Number of installed ports, less CPU (for
example, if 8 ports are installed, 7 ports
are listed). One port (B4) is reserved for
CPU.
Bandwidth of ports on each installed I/O
module. Bandwidth used to distinguish
between four port (155 Mbps) and single
port boards (622 Mbps).
IP address of the switch.
Base MAC (media access control)
address for the board. There are 128
addresses, starting at this base address.
The first is used for the Ethernet port.
The ATM stack uses all the addresses
(including the first).
Type of switch software package.
Version of the software.
Value/Field Size
kilobytes/Up to 5 characters
Redundant, Non-Redundant
1 character
1 character
1 character
1 character
k cells
1, 2, 3, 4
n/a
1, 2, 3, 4...
n/a
155 Mbps, 622 Mbps
0.0.0.0 - 255.255.255.255
00:20:d4:XX:XX:XX
Server
X.X
SmartCell 6A000/ZX-250 Reference Manual 2-203