Table of Contents
Advertisement
Appendix C: Optional Installations and Mode Switch Bank Settings
2.
If the 2E43-51 is rack mounted, remove it from the rack and remove
the rackmount brackets (refer to
and Mode Switch Bank
3.
Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See
4.
Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off of the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
Front Panel
Note: If the device was rack mounted, the four screws fastening the cover to
the front panel are removed and installed along with the rackmount brackets.
C.2.1
Setting the Mode Switch
Figure C-2
shows the location of the mode switches and the switch
settings for normal operation. These switches are set at the factory and do
not need to be changed.
C-4
Settings).
Figure
C-1.)
Figure C-1 Removing the Chassis Cover
Chapter
3,
Optional Installations
2E43-51/2E43-51R User's Guide
Chassis Cover
Cover Screws (7)
Chassis
2251-30
Advertisement
Table of Contents
