The Parts Of The Method Status Screen - PerkinElmer 200 UV/VIS Series User Manual

Using Method Mode

The Parts of the Method Status Screen

The following figure identifies the method status, and some parts of the Method Screen.
1
The following table describes the parts of the Method Screen.
Part of the
Number
Screen
1 Method Name
2 Method Number
3 Method Status
4 Detector Status
5 Sequence Status
4 - 4
2 3 4
Allows up to eight characters to identify the method. The
method name is optional.
The number that identifies the method.
One of the following appears:
STORD: Indicates the method is stored in memory.
CHNGD: Indicates a method value has changed. This
remains displayed until you store the method.
This field is blank when you are creating a new method.
One of the following appears:
NTRDY: Indicates Not Ready. This status appears when
the detector is not ready to run, for example when the
lamp is off.
READY: Indicates Ready. This status appears when the
detector is ready to run a method.
RUNnn: Indicates Running. This status appears when
the Detector is running.
STOPD: Indicates Stopped. This status appears when the
Stop key has been pressed while a method was running.
Displays the sequence status. In the figure above the
sequence status is S01.000. The "S" indicates "Sequence."
The "01" indicates the current set, and "000" indicates the
current injection.
Viewing the Method Screen
5
Description
6
7
8