PerkinElmer 200 UV/VIS Series User Manual page 117

Setting Configuration Options
Setting the Analog Output
You can set the detector's analog output options to correspond to the attached data handling
system. When you press the ANLG softkey, the detector displays the Analog Output Setup
Screen. This screen allows you to set the following:
• Analog Offset
Allows you to offset the value of the detector output to a positive value to allow for any
potential negative drift.
• Computer Output
Allows to you to set the number of volts per absorbance unit.
• Recorder Adjust
Allows you to calibrate/check the recorder (manual mode only).
To view the Analog Output Setup Screen, follow the procedure below.
From the Instrument Setup Screen, press F3
1
To accept the entry and move to the next field, you can use either the cursor arrow keys, or
2
the key.
enter
ANALOG OUTPUT SCREEN
Configuring the Detector
to move to the Analog Output Screen.
ANLG
6 - 7