Scanning The Chromatogram - PerkinElmer 200 UV/VIS Series User Manual

Using Manual Mode

Scanning the Chromatogram

Scanning lets you scan the sample in the flowcell across the selected wavelength range after
stopping the flow. Scanning allows you to create, on the recorder, a spectrum of the sample
trapped in the flowcell. The Scan command tells the detector to scan across all wavelengths
in the sample cell. To best correlate the scan wavelength, you can have the recorder mark
the output at a specified interval.
From the Detector Manual Settings Screen, press F8
1
Screen.
Press the
2
to enter the parameters in each field as shown in the table on the next page.
3 - 8
DETECTOR MANUAL SETTINGS SCREEN
SCAN SCREEN
key to move from one field to the next. Then use the numeric keypad
enter
Scanning the Chromatogram
F8
to move to the Scan
SCAN