Warnings From The User's Manual; Generic Warnings; Moving The Detector; High Voltage - PerkinElmer 200 UV/VIS Series User Manual

Table of Contents

Safety and Regulatory Information

Warnings from the User's Manual

Before installing or operating the Detector, read the following information concerning haz-

ards and potential hazards. You should ensure that anyone involved with installation and/or

operation of the instrument is knowledgeable in both general safety practices for the labora-

tory and safety practices for the. Detector. Get advice from your safety engineer, industrial

hygienist, environmental engineer, or safety manager before you install or use the instru-

ment.

Although the Series 200 UV/VIS Detector weighs only 11.4 kg (25 lbs), improper lifting can

cause injury to the back. Exercise caution when lifting.

The Series 200 UV/VIS Detector contains high voltage (up to 375 volts). Before removing the

outside cover to change the lamp, detach the line cord from the Detector and wait at least

one minute.

The deuterium lamp emits ultraviolet radiation. Exposure to ultraviolet radiation can cause

permanent damage to the eyes and blindness. This can occur by opening the detector head.

You must wear approved protective goggles whenever there is a potential for exposure to

ultraviolet radiation from the deuterium lamp. The instrument should be turned off and

unplugged before removing or exchanging the lamp. The lamp must be correctly positioned

in its cradle before operating the detector.

S - 20

Table of Contents