PerkinElmer 200 UV/VIS Series User Manual page 89

Editing the Current Method
In the RSP/PW field, press the corresponding softkey to enter the value for the
4
"Smoothing" mode. This field displays either RSP or PW depending on the detec-
tor's configuration. For more information on selecting the correct value, see the
"Detector Response Time" topic in Chapter 8, Principles.
In the AZ field, press the
5
softkey to unselect Autozero.
When you are finished entering the control parameters for Step 1, you can press the
6
key to go back to the Method Screen, or you can add another Step to the
return
method.
To add another Step to the method, press the
7
To move from one Step to another, press the
you to enter the step number. Use the numeric keypad to type the number, then
press the
To save the changes to the method you can store it. For information on storing the
method, see the "Storing a Method" topic later in this chapter.
Press the
When you make changes to the parameters, the method status at the top of the
screen switches to CHNGD, for "changed."
softkey to select Autozero, or press the
YES
key.
enter
key to go back to the Method Screen.
return
Using Method Mode
key, or the right arrow key.
enter
softkey. The detector prompts
STEP
No
NO
4 - 9