Setting Up A Sequence - PerkinElmer 200 UV/VIS Series User Manual

Using Sequences

Setting up a Sequence

You can use the LINK command to set up the sequence. The LINK command makes the
selected sequence the current, active sequence. Only one linked sequence is allowed. A
sequence many contain one or more Sets. A Set is the combination of a method number and
the number of injections. A linked sequence requires that you press the Run key to run each
injection in the sequence. A linked method cannot be edited.
To set up the sequence, press F6
changes to LINKD, and the first method in the sequence becomes the active method.
After you press
lamp off at the end of the sequence. If you answer Yes, the
lamp set up screen displays at the end of the sequence.
Press
5 - 8
SEQUENCE SCREEN
F1
, the system asks if you want to turn the
LINK
to turn the lamp back on.
return
. When you link the sequence, its status
LINK
Setting up a Sequence
F8
F6