PerkinElmer 200 UV/VIS Series User Manual page 115

Setting Configuration Options
Setting Up the Lamp
You can use the Lamp Set-Up screen to set the wavelength range you want the lamp to
cover. You make the change in this screen if you do not want to accept the default value for
the installed lamp. The Detector senses the type of lamp installed and automatically dis-
plays the appropriate type. The acceptable lamp types are Deuterium or Tungsten.
The following are the default wavelength ranges:
• 190 - 360 for the Deuterium Lamp (UV)
• 360 - 700 for the Tungsten Lamp (Visible)
When you press the LAMP softkey, the Detector displays the Lamp Setup Screen. When the
Lamp Setup Screen is displayed, you can use the cursor control keys to move to the desired
field.
From the Instrument Setup Screen, press F1
1
λ
the LIMITS field is highlighted.
LAMP SET-UP SCREEN
To accept the entry and move to the next field, you can use either the cursor arrow keys, or
2
the key. To select another option, press the corresponding softkey.
enter
To change wavelength range value in the
The Lamp Status field allows you to turn the lamp on or off. You can turn the lamp off while
3
you are viewing the Lamp Set-Up screen. The detector automatically turns on the lamp
when you exit this screen. To turn the lamp off, press the
back on, press the
To accept and save the change(s) and return to the Instrument Setup Screen, press
4
the key.
return
To cancel changes and return to the Instrument Setup Screen press the
λ
softkey, or press
ON
to move to the Lamp Setup Screen. The
LIMITS field, press the
softkey. To turn the lamp
OFF
key.
return
Configuring the Detector
or softkey.
360 700
key.
quit
6 - 5