Modify The New System File - Adaptec P2280A Manual

5
Type pkginfo -l adstxx and press Enter.
6
Verify that the adst21 or adst70 driver is now listed.
If the adst21 or adst70 driver does not appear in the pkginfo
listing, turn to Troubleshooting on page 5-9.
The listing should be similar to
PKGINST: adst21
NAME: Ultra160 Driver for UnixWare 2.1x
or
PKGINST: adst70
NAME: Ultra160 Driver for UnixWare 7.1

Modify the New System File

1
Display the contents of the adst21 file by typing the following
and pressing Enter:
For UnixWare 2.1x:
cat /etc/conf/sdevice.d/adst21
For UnixWare 7.1:
cat /etc/conf/sdevice.d/adst70
2
If your computer is to boot from a device connected to a
Ultra160 Family host adapter, verify that the line $static is
present immediately below the line $version 2.
3
If your computer is not to boot from the host adapter SCSI bus,
and you wish to leave the driver as a loadable module, edit
and verify that the line $static is not present directly below the
line $version 2.
UnixWare Installation
5-5