Rear Wheel Brake Drum Removal - Club Car TURF 272 Maintenance Manual

6A
MC012C-AS00 TRANSAXLE: HYDRAULIC AND PARK BRAKE SYSTEMS
Front Wheel Brake Drum Removal, Continued:
NOTE: If the adjusters require more than 65 in-lb (7.3 N·m) of force to rotate, they must be replaced. See
Brake Shoe Adjuster Replacement on page 6a-26.
7. Repeat steps 1 through 6 for the opposite front wheel if necessary.
Rotate adjuster bolts
to loosen brake shoes.
Hex
Torx

REAR WHEEL BRAKE DRUM REMOVAL

∆
WARNING
• Use only approved replacement brake drums designed for your vehicle. For MC012C-AS00
transaxles, use CCI P/N 102264701.
1. To remove the rear brake drums, place chocks at the front wheels, release the park brake, loosen the rear
wheel lug nuts and lift the rear of the vehicle with a chain hoist or floor jack.
2. Place jack stands under the axle tubes to support the vehicle and lower the floor jack or chain hoist so
that the vehicle is resting on the jack stands.
3. Remove the lug nuts and remove rear wheel.
4. Remove the brake drum. If the brake drum was easily removed, proceed to step 6.
5. To remove tight brake drums:
5.1. On the back of each brake cluster assembly, locate the bolt heads of the two brake shoe adjusters.
5.2. Using a torque wrench and a Torx #T-27 driver, or hydraulic brake adjuster (CCI P/N 102169401),
gently rotate the adjuster bolts in order to increase the clearance between the brake shoe lining and
the brake drum (Figure 6a-5, Page 6a-10). See following NOTE.
NOTE: If the adjusters require more than 65 in-lb (7.3 N·m) of force to rotate, they must be replaced. See
Brake Shoe Adjuster Replacement on page 6a-26.
Page 6a-10 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
Hex Head
Bolt Wrench
Torx Head
Bolt Wrench
Figure 6a-5 Loosen or Tighten Brake Adjusters
Brake Drum Removal
Rotate adjuster bolts
to tighten brake shoes.
Hex
Torx