Oil Level Sensor - Club Car TURF 272 Maintenance Manual

ELECTRICAL COMPONENTS: FE350, PEDAL-START ENGINE
11. Connect the 18-gauge black wire (12) to the spade terminal (13) on the coil (11) (Figure 12b-26,
Page 12b-27).
12. Position the fan housing close to the engine crankcase and slide the plug wire grommet into the notch
on the housing.
13. When installing fan housing, make sure the top front corner of the housing is above the upper cylinder
shroud. The front edge of the fan housing should be behind the lower cylinder shroud. Align the slots in
the housing with the flanged bolts (6) loosened earlier (Figure 12b-25, Page 12b-27).
14. Install the four remaining flange bolts (10) that secure the fan housing to the engine crankcase. Tighten
all seven mounting bolts to 90 in-lb (10.2 N·m).
15. Install the fan shroud with four pan head bolts (5). Tighten to 50 in-lb (5.7 N·m) (Figure 12b-25,
Page 12b-27).
16. Place the engine onto the engine mounting plate and slide the two washers (3) onto the two engine body
bolts, then slide the bolts through the mounting plate and transaxle housing. Loosely attach the two nuts
(6) finger tight. See Figure 13-41, Section 13, Page 13-23.
17. Attach the engine to the bottom of the engine mounting plate using the bolts (1), washers (2), and nuts
(5). Tighten hardware to 21 ft-lb (28.4 N·m). See Figure 13-41, Section 13, Page 13-23.
18. Tighten the two engine body bolt nuts (6) to 17 ft-lb (23.1 N·m).
19. Install the engine and transaxle assembly. See Unitized Transaxle Installation, Section 16b,
Page 16b-41.
∆
CAUTION
• Make sure wire harness is routed and secured away from the muffler.
20. Install the muffler. See Muffler Installation, Section 15, Page 15-3.
21. Install the starter/generator and belt. See Starter/Generator Installation on page 12b-11.
22. Connect the spark plug wire to the spark plug.
23. Connect the battery cables, positive (+) cable first, and tighten the terminals to 20 ft-lb (27.1 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
24. Place the neutral lockout cam in the OPERATE position.
25. Lower the cargo bed. See WARNING "For vehicles with cargo beds..." on page 12b-2.

OIL LEVEL SENSOR

Read DANGER and WARNING on page 12b-1.
Testing the Oil Level Sensor
See Test Procedure 21, Section 11b, Page 11b-43.
Oil Level Sensor Removal
See Oil Level Sensor Installation, Section 13, Page 13-24.
Oil Level Sensor Installation
See Oil Level Sensor Installation, Section 13, Page 13-24.
2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
12B
Oil Level Sensor
Page 12b-29