Cylinder Block - Club Car TURF 272 Maintenance Manual

FE350 AND FE400 ENGINES
Measure each position
in 2 places, 90° apart.
1
A
2
A
Figure 13-54 Measure Piston Pin O.D.
6. If the inside diameter exceeds 1.479 inches (37.567 mm), replace the connecting rod. See following
NOTE.
NOTE: If the connecting rod is bent or twisted, it must be replaced.
The connecting rod and cap must stay together as a set. Do not mix with parts from any other
engine.
Measure each
position in
2 places,
90° apart.
Figure 13-56 Measure Connecting Rod
Small Bore I.D.

CYLINDER BLOCK

Read DANGER and WARNING on page 13-1.
While the engine is disassembled, inspect the cylinder block for cracks, stripped bolt holes, broken fins, or cyl-
inder wall scoring. Repair or replace as necessary.
1. Use an inside micrometer or telescoping gauge, together with a micrometer, to measure the cylinder
bore.
2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
1
A 1
A
1
1
B B
1
1
C C
1
1
D D
1 2
A A
Figure 13-55 Measure Piston Pin Hole I.D.
1 2
A A
Measure each
position in
2 places,
90° apart.
Figure 13-57 Measure Connecting Rod
Large Bore I.D.
13
Cylinder Block
1
A
2
A
Measure each
position
in 2 places,
90° apart.
Page 13-29