FE350 AND FE400 ENGINES
OIL
PUMP
1
2
Figure 13-69 Oil Pressure Relief Valve
Oil Pump Installation
∆
CAUTION
• Do not allow any dust or other foreign matter into the oil pump.
1. Installation is the reverse of removal.
2. Install the inner rotor with its tang in the slot in the end of the camshaft (Figure 13-71, Page 13-35).
3. Install six bolts (1-6) and finger-tighten. Then tighten to 7 ft-lb (9.5 N·m) in the sequence shown
(Figure 13-64, Page 13-33). After tightening bolts, check the torque of the first bolt.
SLOT
6
Figure 13-71 Install Inner Rotor
2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
3
5
TANG
3
Figure 13-70 Measure Free Length of Spring
13
Oil Pump
Page 13-35