Club Car TURF 272 Maintenance Manual page 550

16B
MC010C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Installation, Continued:
WOODEN
BLOCKS
Figure 16b-95 Transaxle Mounting
8. Install the governor cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb (15.1 N·m)
(Figure 16b-98, Page 16b-43).
9. Install governor lever arm on governor shaft (Figure 16b-99, Page 16b-43). With the governor lever arm
loose on the governor shaft, turn the governor arm shaft counterclockwise until it stops. Then pull the
governor lever arm rearward until the carburetor throttle is in the "wide open throttle" (WOT) position
(Figure 16b-99, Page 16b-43).
10. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever nut
to 35 in-lb (4.0 N·m) (Figure 16b-99, Page 16b-43).
11. Install the key onto the input shaft (Figure 16b-100, Page 16b-44).
12. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and
mounting bolt. Tighten the mounting bolt to 14 ft-lb (19.0 N·m) (Figure 16b-100, Page 16b-44).
13. Install the drive belt. See Drive Belt Installation, Section 17, Page 17-5.
14. Remove the blocks from under the engine and roll the powertrain into position under the vehicle. Then
lift the front of the powertrain and place the snubber into the snubber bracket in the vehicle frame
(Figure 16b-101, Page 16b-44).
2
Figure 16b-96 Differential Lock Bracket Installation
Page 16b-42 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
TRANSAXLE MOUNTING BOLT AND NUT
(TYPICAL 4 PLACES)
TRANSAXLE MOUNTING NUTS
(TYPICAL 2 PLACES)
1
Unitized Transaxle Installation
BRACKET
Figure 16b-97 Accelerator Cable Bracket