Club Car TURF 272 Maintenance Manual page 460

16A
MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Axle Shaft, Bearing, and Oil Seal Removal, Continued:
23
25
26
27
Figure 16a-6 Axle Retaining Ring Pliers
6. To remove the wheel bolt flange on the MC012C transaxle (Figure 16a-6, Page 16a-6):
6.1. Remove rubber boot (26) from large flat washer (23).
6.2. Remove cotter pin (25) from locking nut cap (27).
6.3. Remove the locking nut cap (27) from the flanged nut (24).
6.4. Remove the flanged nut (24) and large flat washer (23) from the axle end.
6.5. Remove the wheel bolt flange (22) from the splined axle end.
7. Using a 90° internal snap ring pliers (.090 tip), remove internal retaining ring from axle tube
(Figure 16a-6, Page 16a-6).
8. Carefully pull the axle shaft straight out of the axle tube. The axle bearing will slide out of the axle tube
with the axle shaft.
9. Use a 16 inch (40 cm) rolling head prybar to remove the oil seal (Figure 16a-7, Page 16a-6). Insert the
prybar under the inside lip of the seal and pull the oil seal out (Figure 16a-8, Page 16a-6). Discard the
oil seal. See following CAUTION.
∆
CAUTION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal. A damaged
tube might have to be replaced.
10. Inspect the bearing. If the bearing is damaged or worn, replace it.
Page 16a-6 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
22
24
Insert prybar under
seal, then pull seal out
of its axle tube seat.
Figure 16a-8 Seal Lip
Figure 16a-7 Rolling Head Prybar
Axle Shaft