Club Car TURF 272 Maintenance Manual page 464

16A
MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Removal, Continued:
Figure 16a-10 Carburetor Vent Tube
5.7. Disconnect the engine ground wire from the oil filler tube mounting bracket (Figure 16a-17,
Page 16a-12).
5.8. Loosen nuts securing shifter cable to shifter cable mounting bracket. Then disconnect the shifter
cable rod end from the shifter arm on the unitized transaxle and remove the cable from the cable
mounting bracket (Figure 16a-18, Page 16a-12).
5.9. Remove screws (2) securing the Forward/Reverse shifter cable bracket (1) to transaxle and remove
the shifter bracket (Figure 16a-40, Page 16a-19).
5.10. Loosen nut (3) and bolt (7) on transaxle shifter lever and remove lever from shaft (15)
(Figure 16a-40, Page 16a-19).
5.11. Remove woodruff key (9) from shifter shaft (15) (Figure 16a-40, Page 16a-19).
5.12. Mark for proper reconnection and then disconnect the 6-gauge white wire (F2 post), 6-gauge black
ground wire (A2 post), and 16-gauge yellow wire (DF post) from starter/generator (Figure 16a-19,
Page 16a-12).
5.13. Disconnect the engine oil level sensor wire (18-gauge yellow) at the bullet connector just to the rear
of the starter/generator (Figure 16a-20, Page 16a-12).
CLAMP
Figure 16a-11 Air Intake Hose
Page 16a-10 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
CLAMP
Unitized Transaxle Removal
IMPULSE LINE
Figure 16a-12 Impulse Line