Club Car TURF 272 Maintenance Manual page 384

13
FE350 AND FE400 ENGINES
Oil Level Sensor Removal
1. If not already removed, remove crankcase cover. See Crankcase Cover Removal on page 13-22.
2. Disconnect the oil level sensor wire (2) from the cord connection (1) (Figure 13-44, Page 13-24).
3. Remove the two mounting screws (8) from inside of the crankcase cover and remove the oil level sensor
and bracket.
4
5
Figure 13-42 Crankcase Cover
Oil Level Sensor Installation
1. If the oil level sensor was removed from the bracket, install sensor (6) into bracket (5) and secure with
three screws (7) and tighten to 17 in-lb (1.9 N·m) (Figure 13-44, Page 13-24).
2. Position the sensor and bracket on inside of crankcase and install two mounting screws (8).
3. Connect sensor wire (2) to cord connector (1) (Figure 13-44, Page 13-24).
4. Install screw (3) through wire clamp and into crankcase cover. Tighten to 30 in-lb (3.4 N·m).
1
9
Figure 13-44 Oil Level Sensor
Page 13-24 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
1
3
2
4
6
5
8
TYPICAL 3
TYPICAL 2
PLACES
PLACES
2
5
Figure 13-43 Oil Level Sensor Wire
3
7
Figure 13-45 Timing Mark Alignment
STARTER/
GENERATOR
12
A A
Crankcase
11