Club Car TURF 272 Maintenance Manual page 525

MC010C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Figure 16b-36 Driven Clutch
18. Loosen, but do not remove, the governor arm retaining bolt. Remove the governor arm from the shaft
(Figure 16b-37, Page 16b-17).
19. Remove screws securing the governor cable bracket to transaxle (Figure 16b-38, Page 16b-17).
20. Remove screws securing the accelerator cable bracket to transaxle (Figure 16b-39, Page 16b-17).
NOTE: The governor cable and the accelerator cable should remain attached to the governor arm.
21. Remove the two bolts that secure the differential lock cable bracket to the transaxle housing and unhook
the cable spring from the differential lock arm (Figure 16b-40, Page 16b-18).
22. Remove the six bolts mounting the unitized transaxle to the engine.
22.1. Remove four transaxle mounting bolts (one at each corner of the transaxle mounting plate) as
shown (Figure 16b-41, Page 16b-18).
22.2. Remove two middle transaxle mounting nuts as shown (Figure 16b-41, Page 16b-18).
23. Remove leaf springs, wheels and brake assemblies from transaxle.
Figure 16b-38 Governor Cable Bracket
2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
RETAINING BOLT
BRACKET
Unitized Transaxle Removal
GOVERNOR ARM
RETAINING BOLT
Leave cable
connected.
Figure 16b-37 Governor Arm
Figure 16b-39 Accelerator Cable Bracket
16B
Leave cable
connected.
Page 16b-17