16B
MC010C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Installation, Continued:
36. Check that all wiring is secured properly. See following WARNING.
∆
WARNING
• If wires are removed or replaced make sure wiring and wiring harness is properly routed and
secured to vehicle frame. Failure to properly route and secure wiring could result in vehicle
malfunction, property damage or personal injury.
37. Connect the spark plug wire.
38. Connect the battery cables, positive (+) cable first, and tighten terminals to 20 ft-lb (27.1 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
39. Adjust the engine RPM setting. See Engine RPM Adjustment, Section 14, Page 14-14.
40. Lower the cargo bed. See WARNING "For vehicles with cargo beds..." on page 16b-2.
Figure 16b-114 Carburetor Vent Tube
Step 1
Page 16b-48
2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
CLAMP
Figure 16b-115 Differential Cable End Installation
Step 2
Unitized Transaxle Installation
Step 3