Rocker Arm And Push Rod Removal; Cylinder Head Removal - Club Car TURF 272 Maintenance Manual

13
FE350 AND FE400 ENGINES
Cylinder Shroud Removal, Continued:
10. If the engine is to be totally disassembled, drain oil and remove the oil filter. If only the cylinder head is
to be disassembled, proceed without draining the oil or removing the oil filter.
11. Disconnect oil filler tube (20) from cylinder shroud by first removing the lock nut (18), ground wire (17)
and flange nut (10) and then pulling oil filler tube out of the crankcase cover (Figure 13-8, Page 13-10).
NOTE: Make sure vehicle is level before removing filler tube. This will prevent oil from spilling when filler
tube is removed.
12. Remove the nine bolts (14) and two-ended bolt (11) (Figure 13-8, Page 13-10 and Figure 13-9,
Page 13-10).
13. Take off the head shroud (13), the upper shroud (23) and the bracket (22).
23
TYPICAL 4
PLACES
14
Figure 13-8 Upper Shroud & Oil Filler Removal

ROCKER ARM AND PUSH ROD REMOVAL

NOTE: The FE350 and FE400 engines are equipped with hydraulic lifters, which automatically eliminate
all clearance in the valve train. Therefore, the rocker arms (3) and the push rods (5) do not need to
be put back in their original positions (Figure 13-11, Page 13-11).
1. Remove the two bolts (1) and remove the rocker cover (2) along with the breather tube (3) (Figure 13-10,
Page 13-11).
2. Remove the E-ring (1) and pull the rocker shaft (2) out of the cylinder head (Figure 13-11, Page 13-11).
3. Lift out the rocker arms (3), washer (4), and push rods (5).

CYLINDER HEAD REMOVAL

1. Remove the six bolts (1) and take off the cylinder head assembly (2) (Figure 13-12, Page 13-11).
2. Remove head gasket (3). Note the position of the two dowels (4) as shown (Figure 13-13, Page 13-11).
Page 13-10 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
17
10
18
19
22 20
21
14
13
12
11
14
TYPICAL 5
PLACES
14
Figure 13-9 Head Shroud Removal
Cylinder Head