Accelerator Pedal; Accelerator Pedal Removal - Club Car TURF 272 Maintenance Manual

5
ACCELERATOR AND BRAKE PEDAL ASSEMBLIES
Brake Pedal Installation, Continued:
Figure 5-2 Jack Stand Location on I-Beam
2. Attach the equalizer rod (10) to the brake pedal weldment assembly (1) as shown (Figure 5-1,
Page 5-3). Tighten to 17 in-lb (1.9 N·m).
3. Position and attach brake pedal assembly and mounting blocks (5) with bolts (7), washers (6), and lock
nuts (4) to vehicle frame as shown. Tighten to 70 in-lb (7.91 N·m) (Figure 5-1, Page 5-3).
4. Pull the brake pedal toward the rear of the vehicle until the brake stop bumper will not allow the pedal to
travel any further (Figure 5-5, Page 5-6).
5. Adjust the brake pedal. See Brake Pedal Adjustment on page 5-6.

ACCELERATOR PEDAL

Read DANGER and WARNING on page 5-1.

ACCELERATOR PEDAL REMOVAL

1. Make sure the key switch is OFF and the Forward/Reverse handle is in NEUTRAL.
∆
WARNING
• Disconnect both battery cables, negative (–) cable first.
2. Disconnect the spark plug. See WARNING "To avoid unintentionally starting..." on page 5-1.
3. Place chocks under the rear wheels and lift the front end of the vehicle with a chain hoist or floor jack.
Place jack stands under the outer front I-beam of the vehicle frame and lower the vehicle onto the jack
stands.
4. Using a 9/16-inch socket and 9/16-inch wrench, remove the nut (23), two washers (25), and bolt (4)
securing the accelerator pedal (1) to the pivot rod (6) (Figure 5-11, Page 5-10).
Page 5-4 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
Installation
Figure 5-3 Brake Pedal Weldment Through Floor
Accelerator Pedal
Removal