Club Car TURF 272 Maintenance Manual page 500

16A
MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Installation, Continued:
Figure 16a-103 Shock Absorber
25. Connect the 6-gauge white wire to the F2 post, the 6-gauge black ground wire to the A2 post and tighten
to 48 in-lb (5.4 N·m). Connect the 16-gauge yellow wire to the DF post on the starter/generator and
tighten to 30 in-lb (3.4 N·m) (Figure 16a-105, Page 16a-47).
26. Connect the Forward/Reverse shifter and bracket to the transaxle.
26.1. Install the three screws (2) securing the Forward/Reverse shifter cable bracket (1) to transaxle and
tighten them to 135 in-lb (15.3 N·m) (Figure 16a-40, Page 16a-19).
26.2. Place the woodruff key (9) on the shifter shaft (Figure 16a-40, Page 16a-19).
26.3. Place the shifter lever (6) (aligned with the woodruff key) onto the Forward/Reverse shaft (15).
26.4. Install the nut (3), washer (4), and bolt (7) on the Forward/Reverse shifter lever and tighten to 23 in-
lb (2.6 N·m) (Figure 16a-40, Page 16a-19).
26.5. Position the shifter cable in the shifter cable mounting bracket on the transaxle and tighten the
mounting nuts to 22 ft-lb (29.8 N·m). Connect shifter cable rod end to the shifter arm
(Figure 16a-106, Page 16a-47).
27. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50 in-
lb (5.7 N·m) (Figure 16a-107, Page 16a-47).
28. Connect accelerator cable to actuator cam in the electrical box. Position the accelerator cable in mount-
ing slot in the wall of the electrical box and tighten mounting nuts to 18 in-lb (2.0 N·m) (Figure 16a-108,
Page 16a-47). Install electrical box cover and tighten mounting screw.
29. Pull fuel line from impulse line fitting of the fuel pump, connect it to the carburetor and secure with a hose
clamp (Figure 16a-109, Page 16a-47).
Page 16a-46 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
Unitized Transaxle Installation