Rear Wheel Brake Drum Installation - Club Car TURF 272 Maintenance Manual

MC012C-AS00 TRANSAXLE: HYDRAULIC AND PARK BRAKE SYSTEMS
∆
CAUTION
• Do not apply more than 65 in-lb (7.3 N·m) of torque to any of the adjuster bolts. Over-
tightening the adjuster bolts could result in damage to the brake cluster components or the
separation of the bolt (4) from the adjuster (3) (Figure 6a-3, Page 6a-4 or Figure 6a-21,
Page 6a-25).
20. Install the wheel and finger-tighten the lug nuts (21) (Figure 6a-3, Page 6a-4).
21. Repeat steps 1 through 20 for the opposite front wheel as required.
22. Lower the vehicle and finish tightening the lug nuts, using a crisscross pattern, to 55 ft-lb (74.6 N·m).
23. Check the front wheel free play. See Front Wheel Free Play Inspection, Section 7, Page 7-21.
24. Perform all of the brake system inspections to ensure that both the hydraulic brake system and the park
brake system are adjusted correctly and are operating correctly before placing the vehicle into service.
See Brake System Inspection on page 6a-3.
Rotate adjuster bolts
to loosen brake shoes.
Hex
Torx

REAR WHEEL BRAKE DRUM INSTALLATION

NOTE: Prior to installing the brake drum, inspect the brake lines, hoses, drums and brake cluster assem-
blies. See Brake System Inspection on page 6a-3.
∆
WARNING
• Use only approved replacement brake drums designed for your vehicle. For MC012C-AS00
transaxles, use CCI P/N 102264701.
1. Place the brake drum (15) onto the wheel bolt flange and brake cluster (Figure 6a-21, Page 6a-25).
2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
Hex-Head
Bolt Wrench
Torx-Head
Bolt Wrench
Figure 6a-16 Loosen or Tighten Brake Adjusters
Brake Drum Installation
Rotate adjuster bolts
to tighten brake shoes.
Hex
Torx
Page 6a-19
6A