Club Car TURF 272 Maintenance Manual page 518

16B
MC010C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Removal, Continued:
Figure 16b-12 Carburetor Vent Tube
CLAMP
Figure 16b-13 Air Intake Hose
5.5. Remove the differential lock cable.
5.5.1. Place differential lock handle in the disengaged direction.
5.5.2. Using a pair of pliers, apply pressure to the locking tabs of the cable end (1) where it
5.5.3. While maintaining pressure on the locking tabs, pull the differential lock cable toward the
5.5.4. With handle in the engaged position and the cable disconnected from the bracket, rotate
5.5.5. Remove wire tie (6) securing the cable to the vertical support (Figure 16b-119,
5.6. Remove the cover from the electrical component box. Then loosen the hardware securing the
accelerator cable to the box. Disconnect the cable from the actuator cam and remove it from the box
(Figure 16b-18, Page 16b-12).
5.7. Disconnect the engine ground wire from the oil filler tube mounting bracket (Figure 16b-19,
Page 16b-12).
Page 16b-10 2001/2002 Turf/Carryall 272 Gasoline Vehicle Maintenance and Service Manual
CLAMP
attaches to the differential lock handle mounting bracket (Figure 16b-15, Page 16b-11).
rear of the vehicle to disconnect the cable from the bracket (Figure 16b-15, Page 16b-11).
the cable connector toward the driver side of the vehicle to disconnect the cable from the
differential lock lever (1) (Figure 16b-16, Page 16b-12).
Page 16b-53).
Unitized Transaxle Removal
IMPULSE LINE
Figure 16b-14 Impulse Line