Setting Network Properties - HP Open View Installation And Maintenance Manual

Completing the Appliance Setup

Setting network properties

Before shipping the appliance, HP Manufacturing enters information for each appliance node
using the CASA setup utility window. This information enables the appliance nodes to
identify and communicate with each other.
Table 5
At the customer site, you must update the LAN Interface network information. If the customer
uses IP mirroring, you must also update the MirrorLink network information. You do not have
to change the InterLink information.
HP Manufacturing generates the serial ID, which has the following format:
The same serial ID is used for both appliance nodes.
Note:
CASA setup utility window to accommodate older installations.
Table 4: Settings for node 0
Peer Node General – Settings
LAN Interface
MirrorLink
InterLink
42
lists the information entered for node 1.
CC—Country code
S—Site code
YY—Last two digits of the year (04, 05)
WW—Two digits representing the week (01–52)
XXX—Sequence number
The previous serial ID format, which included the prefixes usra and usrb, will work in the
Field
Host name
Node id
Serial id
Peer IP address
IP Address
Subnet Mask
Default Gateway
IP Address
Subnet Mask
Default Gateway
IP Address
Subnet Mask
Default Gateway
Table 4 lists the information entered for node 0;
Node 0
0
CCSYYWWXXX
10.0.1.2
10.100.70.130
255.255.255.0
10.100.70.1
10.0.2.1
255.255.255.0
blank
10.0.1.1
255.255.255.0
blank
Continuous Access Storage Appliance Installation and Maintenance Guide
Value