Manually Configuring Port Access - HP Open View Installation And Maintenance Manual

Manually configuring port access

To manually configure port access:
1. Ensure the hp OV CASA Console window is open in administrative mode.
2. Click switchui to open the Windows NT desktop. See
3. Click Start > Settings > Control Panel.
4. Click Network.
5. Click the Protocols tab, click TCP/IP Protocol, and then click Properties.
6. Select the LAN Interface adapter in the Adapter list and click Advanced.
7. Click the Enable Security check box, which enables the Configure button.
8. Click Configure.
9. Add and set access to the specific ports, using the information in
Figure 7: Network dialog box
Continuous Access Storage Appliance Installation and Maintenance Guide
instructions.
The Control Panel window opens.
The Network dialog box opens
The Microsoft TCP/IP Properties dialog box opens
The Advanced IP Addressing dialog box opens
The TCP/IP Security dialog box opens
"Using
(Figure 7).
(Figure
(Figure
(Figure 10).
Completing the Appliance Setup
switchui" on page 28 for
8).
9).
Table 3.
39