Table of Contents
Advertisement
Starting the software services
To start the software services:
1. Set the console display to node 0.
2. Ensure that the hp OV CASA Console window is open in administrative mode.
3. Click service viewer.
4. Select the RPIC DPF service and set it to Automatic.
5. Click Apply and then click Start.
Note:
6. Select each of the following services and verify that they are set to Automatic and that the
7. Close the Services window.
8. Set the console display to node 1 and repeat steps 2 through 7 on node 1.
Continuous Access Storage Appliance Installation and Maintenance Guide
The hp OV CASA Console window opens.
The Services window opens.
It may take a few minutes for the RPIC DPF service to start.
status is Active. If a service is not set to Automatic and the status is not Active, repeat
steps 4 and 5.
Identification and Authorization Server
sv3000 Management Server (SMS)
Tomcat
VA Status Monitor
WebServer
Completing the Appliance Setup
47
Advertisement
Table of Contents
Need help?
Do you have a question about the Open View and is the answer not in the manual?
Questions and answers