Table of Contents
Advertisement
Replacing and Configuring Appliance Components
9. Enter the following command:
10. When you see the following message, enter n:
11. Enter the following command:
12. When you see the following message, enter y:
13. Close the Hyper Terminal window.
14. Click Yes to disconnect.
15. Remove the serial cable connection.
16. Reboot both appliance nodes.
Detecting the array
To enable the peer node to detect the array:
1. Ensure that the hp OV CASA Console window is open in administrative mode.
2. Click service viewer.
3. Select one of the following services and click Start:
4. Repeat step 3 for the other service listed.
5. Close the Services window.
6. From the console window, press Alt+C to open a command prompt window.
7. At the c:\ prompt, enter:
When the discovery process is complete, the driver information is displayed, indicating
successful detection of the array.
If the peer node does not detect the array, the following error message is displayed:
Device not found.
If this occurs, contact the CASA support team (support_team@hp.com).
102
mgr –os nt -t 1 –c 1 -S 2 -hp 1 (for controller 1 on host port 1)
Topology will be set to: Private Loop. Change will take
effect after a reset. Do you wish to reset now? (y/n)
mgr –os nt -t 1 –c 2 -S 2 -hp 1 (for controller 2 on host port 1)
Topology will be set to: Private Loop. Change will take
effect after a reset. Do you wish to reset now? (y/n)
The Services window opens.
HP OpenView SAM OpenDial
HP OpenView HostAgent
armdiscover
Caution:
The discovery process can take a few minutes. Canceling this process once it has
started will corrupt the configuration.
Continuous Access Storage Appliance Installation and Maintenance Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the Open View and is the answer not in the manual?
Questions and answers