Setting Up Snmp (Simple Network Management Protocol); Management Information Bases (Mibs); Configuring Snmp On The Storeonce Management Console; Storeonce Cli - HP StoreOnce 3100 System Installation And Configuration Manual

9 Setting up SNMP (Simple Network Management
Protocol)
There are a number of configuration tasks:
If this is the first StoreOnce System to be added to the network, download the MIBs,
Management Information Bases and register the MIBs with the Network Management
application.
Use the StoreOnce CLI to configure trap sinks and users.
Use the StoreOnce GUI to set up the SNMP agent, for example with system contact details,
and view details of traps, users and events.

Management Information Bases (MIBs)

Two MIBs are used to represent the information handled by the StoreOnce System and they are
called SEMI-MIB.mib and TRAP-DESTINATIONS-MIB.mib. These must be downloaded and
registered with the Network Management application on the host, so that information from the
StoreOnce System can be transmitted to and interpreted by the Network Management host, such
as Insight Remote Support.
To download the MIBs, go to the HPE Support website at http://www.hpe.com/support and
search for your StoreOnce System. Select the Software and driver downloads option and OS
Independent for the operating system. The MIBs are included under the MIB entry.
NOTE: When you connect subsequent StoreOnce Systems to the network, you only need to
update the MIBs if they are later models. For example, once you have downloaded the MIBs
associated with StoreOnce Systems, those MIBs are valid for all subsequent StoreOnce Systems
and any earlier models that are monitored by the Network Management application.
There are typically three stages to setting up the Network Management application for use with
the StoreOnce System:
1. Register SEMI-MIB.mib and TRAP-DESTINATION-MIB within the base of MIBs supported
by the Network Management application.
2. Update the existing system type database with the new system type for the StoreOnce
System, based on the unique system object identifier.
3. Discover the StoreOnce System under the Network Management application.
NOTE: For further information about implementing these three stages, refer to the MIB release
notes and to the documentation supplied with the Network Management application.

Configuring SNMP on the StoreOnce Management Console

StoreOnce CLI

Refer to the HPE StoreOnce CLI Reference Guide for detailed instructions on StoreOnce CLI
commands with syntax for parameters and example output.
Use the StoreOnce CLI at initial configuration to:
Management Information Bases (MIBs) 33