Reconfiguring The Gigabit Ethernet Card; Replacing The Gigabit Ethernet Card - HP Open View Installation And Maintenance Manual

Replacing and Configuring Appliance Components

Reconfiguring the Gigabit Ethernet card

This section describes the procedures for:
The Gigabit Ethernet card replacement specifications as follows:

Replacing the Gigabit Ethernet card

To replace the Gigabit Ethernet card:
1. Ensure that the hp OV CASA Console window is open in administrative mode.
2. Click service viewer.
3. Select the RPIC DPF service, set it to Manual, and then click Stop.
4. Repeat step 3 for the SMS service.
5. Close the Services window.
6. From the console window, click setup.
7. Record the information that displays in this window.
8. Power down the appliance node with the defective card.
9. Disconnect the cables from the card.
10. Replace the defective card.
11. Connect the cables to the new card.
12. Power on the appliance node.
13. Ensure that the hp OV CASA Console window is open in administrative mode.
14. Click setup.
15. Enter the network information you recorded in step 7 and click OK.
16. Click OK when the following message is displayed:
Note:
17. Click service viewer.
18. Select the RPIC DPF service and set it to Automatic.
118
Replacing the Gigabit Ethernet card
Reconfiguring the driver
Part number—A7547-69001
Description—Dual–port Gigabit Ethernet Card
Assembly number—A7547-60001
The Services window opens.
The CASA setup utility window opens.
The CASA setup utility window opens.
The operation completed successfully. Please reboot this
machine for the changes to take effect.
Do not reboot the node at this time.
The Services window opens.
Continuous Access Storage Appliance Installation and Maintenance Guide