Table of Contents
Advertisement
What to do next
After you unpack the appliance:
1. Connect all cables on the appliance.
2. Power on the appliance.
3. Set the current date and local time on the nodes (and switches, if applicable). (See
4. Set the network properties using the CASA Setup Utility. (See
5. Initialize the user database to authenticate the user interface and the command line
6. Configure the hosts and storage arrays that you connect to the appliance. (See
7. Implement path failover, if applicable. (See
8. Complete the wiring between the appliance and the hosts and storage arrays. (See
Continuous Access Storage Appliance Installation and Maintenance Guide
the current date and local
properties" on page 42.)
interface (CLI). (See
"Initializing the user
"Configuring Hosts and Storage
"Connecting the Appliance to Hosts and Storage
time" on page 31.)
database" on page 48.)
Arrays" on page 53.)
Implementing Path Failover
Arrays" on page 81.)
Unpacking the Appliance
"Setting
"Setting network
on page 69.)
21
Advertisement
Table of Contents
Need help?
Do you have a question about the Open View and is the answer not in the manual?
Questions and answers