Setting The Execution Throttle For Qlogic Hbas; Windows 2000 And Windows Nt - HP Open View Installation And Maintenance Manual

Setting the execution throttle for QLogic HBAs

This section describes how to set the execution throttle for QLogic HBA drivers on the
following operating systems:

Windows 2000 and Windows NT

To set the execution throttle for a QLogic HBA driver on a Windows 2000 or Windows NT
host:
1. Power off and then power on the host.
2. Press Ctrl+Q when prompted.
3. Select an adapter and press Enter.
4. Select Configuration Settings and press Enter.
5. Select Advanced Adapter Settings and press Enter.
6. Scroll to Execution Throttle and press Enter to select it.
7. Using the guidelines provided on page 58, enter the appropriate value in the New box and
8. Press Esc to return to the Configuration Settings menu.
9. Press Esc again.
10. Select Save changes and press Enter.
11. To set the execution throttle for other adapters, select Select Host Adapter and press
12. When you finish configuring adapters, select Exit Fast!UTIL and press Enter.
13. Select Reboot System and press Enter.
Continuous Access Storage Appliance Installation and Maintenance Guide
Windows 2000 and Windows NT
Solaris
The Select Host Adapter menu opens.
The Fast!UTIL Options menu opens
The Configuration Settings menu opens.
The Advanced Adapter Settings menu opens.
The Enter Decimal Number dialog box opens.
press Enter.
The Configuration settings modified menu opens
The Fast!UTIL Option menu opens.
Enter. Repeat steps 3 through 10 for each adapter.
The Exit Fast!UTIL menu opens
Configuring Hosts and Storage Arrays
(Figure 12).
(Figure
(Figure 14).
13).
59