Table of Contents
Advertisement
Replacing and Configuring Appliance Components
9. To select a parameter, highlight the parameter name and press Enter. Then specify the
10. Press Esc to return to the Configuration Settings menu.
11. Press Esc again.
12. Click Save changes and press Enter.
13. To reconfigure another HBA, click Select Host Adapter and repeat steps 3 through 12.
14. From the Configuration Settings menu, click Raw Nvram Data.
15. Verify the HBA type of each adapter. Check the value at the intersection of F0 and 0A.
16. When you finished reconfiguring adapters, click Exit Fast!UTIL and press Enter.
17. Click Reboot System and press Enter.
116
value for the parameter listed below.
Execution Throttle—90*
Luns per Target—8
Enable LIP Rest—No
Enable LIP Full Login—Yes
Enable Target Reset—Yes*
Login Retry Count—60*
Port Down Retry—30*
Link Down Timeout—0
Extended Error Logging—Enabled*
RIO Operation Mode—5*
Interrupt Delay Timer—0
An asterisk (*) indicates that you must change the parameter to the value listed.
Parameters without an asterisk show the default value; do not change this value.
The Configuration settings modified menu opens.
The Fast!UTIL Option menu opens.
The Raw Nvram Data window opens.
The value for initiator HBAs is 77; the value for target HBAs is 28.
The Exit Fast!UTIL menu opens.
Continuous Access Storage Appliance Installation and Maintenance Guide
Advertisement
Table of Contents
