Configuring Remote Access; Resetting Security For All Ports - HP Open View Installation And Maintenance Manual

Completing the Appliance Setup

Configuring remote access

If corruption occurs and you need to configure remote access for the ports, you can:

Resetting security for all ports

To reset security for all ports listed in
1. Ensure the hp OV CASA Console window is open in administrative mode.
2. Click switchui to open the Windows NT desktop. See
3. Click Start > Settings > Control Panel.
4. Double-click Network.
5. Double-click Protocol.
6. Select TCP/IP and click Properties.
7. Click Advanced.
8. Click Configure in the Enable security box.
9. Under TCP and UDP, select the Permit All options.
10. Exit all windows and reboot the appliance node when prompted.
11. Press Alt+C to open a command prompt window.
12. To reset port security on the appliance node, enter the following command:
38
Reset security for all ports. (See
Manually configure access for individual ports. (See
instructions.
The Control Panel window opens.
The Network window opens.
The Protocol window opens.
The Properties dialog box opens.
The Advanced dialog box opens.
c:\rpic\utilites\SetPortSecurity E10001
"Resetting security for all
Table 3:
Continuous Access Storage Appliance Installation and Maintenance Guide
ports.")
"Manually configuring port
"Using switchui" on page 28 for
access.")