Installing Version 3.0.0 - HP Open View Installation And Maintenance Manual

Installing version 3.0.0

Note:
To install PowerPath version 3.0.0 on node 0:
1. Insert the EMC PowerPath version 3.0.5 for windows CD into the CD-ROM drive.
2. Ensure that the hp OV CASA Console window is open in administrative mode.
3. Click service viewer.
4. Select the RPIC DPF service, set it to Manual, and click Apply.
5. If the status of the service is Active, click Stop.
6. Repeat steps 4 and 5 for the SMS service.
7. Close the Services window.
8. Press Alt+C to open a command prompt window.
9. To access the CD-ROM drive, enter:
10. To execute the EMCPP.NT4.3.0.0.GA.exe file, enter:
11. Click Next.
12. Enter the customer's name and organization and click Next.
13. Click Next to install the software on the default directory listed.
Note:
14. Click Install.
15. When prompted, enter the 24-digit registration number in the License Key box.
16. Click Add, and then click OK.
17. Click Finish.
18. When prompted to reboot the host, click Yes.
The installation of PowerPath 3.0.0 is complete. Continue with
Continuous Access Storage Appliance Installation and Maintenance Guide
Ensure that you stop the RPIC DPF and SMS services before installing PowerPath.
The Services window opens.
d:
d:\nt4\ EMCPP.NT4.3.0.0.GA.exe
The EMC PowerPath 3.0.0. – Install Shield Wizard Welcome window opens.
HP recommends that you use the default directory.
The Ready to Begin Installation dialog box opens.
The EMC PowerPath 3.0.0. – Install Shield Wizard Completed window opens.
The appliance node is rebooted.
Implementing Path Failover
"Installing version 3.0.5."
77