Replacing A Target/Initiator Hba - HP Open View Installation And Maintenance Manual

Replacing and Configuring Appliance Components

Replacing a target/initiator HBA

To replace a target or initiator HBA:
1. Power down the appliance node with the defective adapter.
2. Disconnect the shared storage Fibre Channel cables from the defective adapter.
3. Replace the defective adapter.
4. Power up the appliance node.
Note:
comply, see
continuing with this procedure.
5. From the console window, click sanos admin > launch.
6. Log in to sanosadmin and enter:
7. When you receive a message that the HBA(s) have been updated, exit sanosadmin.
8. Connect the shared storage Fibre Channel cables to the new adapter.
9. Reboot the appliance node.
10. From the console window, click sanos admin > launch.
11. Log in to sanosadmin and enter:
12. To verify that the nodes can detect each other, enter:
13. Repeat step 12 on the other appliance node.
114
Ensure that the new adapter's BIOS complies with the current SANOS version. If it does not
"Resetting the firmware parameters for an initiator
mod hba –updatehbas
mod hba –updatetargets
get node
Continuous Access Storage Appliance Installation and Maintenance Guide
HBA" on page 115 before