9.2
Reading data from the start up screen
The start up screen shows important data like the last calibration,
the current voltage and the firmware version.
This screen stays active as long as the "" button is kept pressed
during the power on of the RadEye device.
The RadEye doesn't show the menu items as
9.3
described in the manual
The items available in the RadEye menu can be disabled or ena-
bled via the RadEye.EXE software. The factory setting has all
menu functions enabled. Please refer to chapter 7.3.8, menu set-
tings. Next, please check the firmware version of your RadEye
SX and compare your version number with the revision table
chapter 12.2. The revision table shows the introduction of new
functions together with the according firmware version.
9-2
DB-070 E
RadEye AB100
Pi/Ff 04.05.2021