Precor Experience 700 Series Service Manual page 130

2. Remove the hood cover, see
3. Remove the four #3 Phillips fasteners and remove the Power Entry Assembly bracket
. Hold the bracket while removing to prevent wire cable damage. Retain part(s)
and/or fastener(s) for installation.
4. Disconnect the ASL interface cable RJ11 connector, see
page 117.
5. Remove the ASL PCA Bracket
tom (underside) of the Power Entry Assembly Bracket
bracket.
6. Unsnap the ASL PCA
tab clip to remove.
Installation Instructions
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Hood Cover Replacement" on
by pressing the inner and outer tab clips on the bot-
board from the ASL PCA Bracket
6 Replacement Procedures
ASL PCA Replacement
page 88.
"Wire Diagram" on
while lifting the ASL
by pressing the outer
Page 120