Precor Experience 700 Series Service Manual page 89

8. Reinstall the extension tube into the lift platform mounting bracket and secure using
the hitch pin and clevis pin. It may be necessary to slightly rotate the extension tube to
align the clevis pin mounting holes. Choose an adjustment direction that will minimize
the change to the extension tube calibration distance. Firmly hold the jackscrew from
turning while adjusting (rotating) the extension tube.
Operation Verification
9. Return the treadmill to the upright position making sure the treadmill is stable and set-
ting level on the floor, see either the
on the next page.
10. Reinstall the hood.
11. Connect the power cord and switch the power ON.
12. Verify incline operation from the minimum to maximum levels. Verify that the incline
reaches maximum and minimum levels and the up/down movement is smooth. Verify
that there are no unusual noises.
13. Do the Operation Verification tests (see
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Side access" on page 82
"Operation Verification" on
5 Adjustment Procedures
Lift Motor Calibration
or the "Front access"
page 24) and
Page 79