Precor Experience 700 Series Service Manual page 110

5. Reinstall the end cap cover onto the end of the frame rail and press to lock cover tabs
in place.
6. Secure using two #3 Phillips screw fasteners. One screw on the top and one screw on
the back. Fully tighten both screws.
7. Repeat the same installation procedure to install both the left and right trim end cap
covers.
1. Remove the back cover , see
2. Remove the console, refer to the treadmill assembly guide on precor.com.
3. Remove the four #3 Phillips screw fasteners and remove the front cover . (miss-
ing or bad snippet)
8. Reinstall the left and right trim landing covers, see
9. Reinstall the hood cover, see
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Covers and Panels Replacement" on
Trim Landing Cover
"Hood Cover Replacement" on
6 Replacement Procedures
Covers and Panels Replacement
page 86.
Replacement.
page 88.
Page 100